>Part Description<

Power Button

Press and hold: Turn the power on/off

Double-click while running: Start recording a new track

Indicator Lamps

Power Lamp

Running

Low Battery*

Charging

Charging Complete

GNSS Lamp

Not Fixed

PVT Fix

RTK Float

RTK Fix

Recording Lamp

No Memory Card

Not Fixed

Recording

　
　

Peripheral Lamp

Peripheral Not Connected

Peripheral Running

　

　
　 　

* When the power lamp starts flashing red, there is approximately 2 hours of battery life remaining.

Data Interface

When powered off: Connect to a computer to enter card reader mode, allowing you to read data from the memory card.

When powered on: Connect to a computer to enter GNSS receiver mode, allowing you to use the EX-1 as a GNSS receiver.

SMA Connectors

From left to right: Bluetooth Antenna Connector (Channel 2), GNSS Antenna Connector, Bluetooth Antenna Connector (Channel 1).

Mounting Holes

There are 4 screw mounting holes distributed on both sides of the main body. M3 countersunk screws can be used to secure the EX-1.

Reset Hole

If the EX-1 is unresponsive, you can use a pin to press the reset hole to perform a reset.

Expansion Port

This interface allows connection to external peripherals.

Peripherals are expected to be available in 2025.